Honda Civic Service Manual: Automatic
- A/T Differential Carrier Bearing Replacement (A/T)
- A/T Gear Position Indicator Panel Assembly Removal and Installation (A/T, CVT)
- A/T Gear Position Indicator Panel Light Harness Removal and Installation (A/T, CVT)
- A/T Housing Countershaft Bearing Replacement (A/T)
- A/T Mainshaft Disassembly, Reassembly, and Inspection (A/T)
- ATF Temperature Sensor Removal and Installation (A/T)
- Automatic Transmission Disassembly and Reassembly (A/T)
- Automatic Transmission End Crankshaft Oil Seal Replacement - In Car (A/T)
- Automatic Transmission Removal and Installation (A/T)
- Carpet Removal and Installation (2-door A/T)
- Carpet Removal and Installation (4-door A/T)
- ECM/PCM Removal and Installation (Except K24Z7 and R18Z1 (CVT))
- Engine Removal and Installation (R18Z1 (A/T, M/T))
- Exhaust Pipe and Muffler Removal and Installation (Except K24Z7 and R18Z1 (CVT))
- Front Driveshaft Disassembly and Reassembly (A/T, M/T)
- Input Shaft (Mainshaft) Speed Sensor Removal and Installation (A/T)
- Line Pressure Solenoid Valve A Removal and Installation (A/T)
- Output Shaft (Countershaft) Speed Sensor Removal and Installation (A/T)
- Park Pin Switch Removal and Installation (A/T, CVT)
- Right A/T Differential Oil Seal Replacement (A/T)
- Rocker Arm Oil Pressure Sensor (EOP Sensor) Removal and Installation (Except K24Z7 and R18Z1 (CVT))
- Secondary HO2S Removal and Installation (Except K24Z7 and R18Z1 (CVT))
- Shift Lock Unit Removal and Installation (A/T, CVT)
- Side Engine Mount Removal and Installation (Except K24Z7 and R18Z1 (CVT))
- Transmission Fluid Pressure Switch A (2nd Clutch) Removal and Installation (A/T)
- ATF Feed Pipe Removal and Installation (A/T)
- A/T Shift Cable Removal and Installation (A/T)
- A/T Shift Lever Removal and Installation (A/T, CVT)
- Torque Converter
- Transmission Unit
Transmission End Cover Selector Control Shaft Oil Seal Replacement (A/T)
2321H3
1.
Vehicle Lift
1.
Raise the vehicle on a lift, and make sure it is securely supported.
...
A/T Differential Carrier Bearing Replacement (A/T)
Removal
NOTE:
The bearing and the bearing outer race should be replaced as
a set.
...
See also:
Honda Civic Owners Manual. Fastening a Seat Belt
After adjusting a front seat to the proper position, and while sitting
upright and well
back in the seat:
Adjusting the Seats
1. Pull the seat belt out slowly.
2. Insert the latch plate into the buckle, then
tug on the belt to make sure the buckle is
secure.
Make sure that the be ...
© 2016-2024 Copyright www.hocivic.com
0.0121