Honda Civic manuals

Honda Civic Service Manual: Output Shaft (Countershaft) Speed Sensor Removal and Installation (A/T)

Honda Civic Service Manual / Powertrain / Transmission/Transaxle / Automatic / Output Shaft (Countershaft) Speed Sensor Removal and Installation (A/T)

2181D9

Removal

1. Air Cleaner


1.

Disconnect the intake air duct (A).

2.

Remove the air cleaner (B).

3.

Remove the harness clamp (C).

2. Output Shaft (Countershaft) Speed Sensor

1.

Disconnect the connector (A).

2.

Remove the output shaft (countershaft) speed sensor (A) with the O-ring (B).

Installation

1. Output Shaft (Countershaft) Speed Sensor

1.

Install the output shaft (countershaft) speed sensor (A) using a new O-ring (B).

2.

Check the connector (A) for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

2. Air Cleaner


1.

Install the harness clamp (A).

2.

Install the air cleaner (B).

3.

Connect the intake air duct (C).

Line Pressure Solenoid Valve A Removal and Installation (A/T)
2321F8 FRONT Removal 1. Line Pressure Solenoid Valve A 1. Disconnect the connector (A). ...

Park Pin Switch Removal and Installation (A/T, CVT)
NOTE: Do not wipe off the special grease applied to the area of the shift lever marked with an asterisk (*) when you disassemble it. 1. Center Console Panel Ass ...

See also:

Honda Civic Owners Manual. Wireless Charger
To use the wireless charger, the power mode must be in ACCESSORY or ON. Charge a compatible device on the area indicated by the mark as follows: 1. To turn the system on and off, press and hold the (power) button. When the system is activated, the green indicator light comes on. ...

© 2016-2024 Copyright www.hocivic.com

0.0085