Honda Civic Service Manual: Side Engine Mount Removal and Installation (Except K24Z7 and R18Z1 (CVT))
112101
|
|
1.
|
Raise the vehicle on a lift, and make sure it is securely supported.
|
|
|
|
|
1.
|
Remove the engine undercover (A).
|
|
| 3. |
Engine Jack Support (State Of A Low Vehicle) |
|
|
1.
|
Lift and support the engine with a jack and a wood block under
the oil pan.
|
|
| 4. |
Mounting Bracket, Engine Side |
|
|
|
1.
|
Remove the ground cable (A), the side engine mount bracket (B),
and the side engine mount (C).
|
|
| 1. |
Mounting Bracket, Engine Side |
|
 125mmnminm.:125mm
|
|
1.
|
Install the new side engine mount mounting bolts (A) and the
side engine mount bracket (B) using a nut and a new bolt, then loosely
install the new side engine mount bracket mounting bolts and nut
(C).
|
|
2.
|
Install the ground cable (D).
|
|
| 2. |
Engine Jack Support (State Of A Low Vehicle) |
|
|
1.
|
Remove the jack and the wood block.
|
|
| 3. |
Transmission Mount Bracket Mounting Bolt - Loosen |
|
M/T
A/T
|
|
1.
|
Loosen the transmission mount bracket mounting bolt and nuts
(A).
|
|
| 4. |
Lower Torque Rod - Loosen |
|
|
|
1.
|
Loosen the lower torque rod mounting bolt (A).
|
|
| 5. |
Side Engine Mount - Tighten |
|
 nxl.mm
|
|
1.
|
Tighten the side engine mount bracket mounting bolt and nut.
|
|
| 6. |
Transmission Mount Bracket Mounting Bolt - Tighten |
|
1.
|
Tighten the transmission mount bracket mounting bolt and nuts.
|
M/T
i2mm
A/T
nz
| 7. |
Lower Torque Rod Mounting Bolt - Tighten |
|
|
|
1.
|
Tighten the lower torque rod mounting bolt.
|
|
|
|
|
1.
|
Install the engine undercover (A).
|
|
1121A5 ENGINE SIDE
Removal
1.
Air Cleaner Assembly
1.
Disconnect the intake air duct (A) and the intake air pi ...
Engine Mounts
Side Engine Mount Removal and Installation (K24Z7)